Skip to content
Mr LeakFind it, fix it,
stop the damage!

Greater London · W1 · W2 · W9 · SW1 · NW1 · NW8 · WC2

Leak detection in Westminster

Non-invasive water leak detection, repair and insurance reporting across Westminster and the surrounding area. Thermal imaging, acoustic correlation and tracer gas find the source precisely — before anyone lifts a floor or opens a wall.

Covered daily by our Central London engineers.

Local knowledge

What actually leaks in Westminster

Westminster combines listed Georgian and Regency stucco terraces in Pimlico, Belgravia and Marylebone with mansion blocks, hotels and offices, and the mansion blocks are a category of their own. Built around 1900 with communal cold water tanks in the roof and cast iron soil stacks in shared voids, a single failure in one of those systems can affect a dozen flats at once, and access to prove the source usually needs a managing agent's cooperation.

That is not trivia. It changes where we start. Knowing that a Westminster property is likely to be on Thames Water mains, built the way most of the stock around it was built, and sitting on the ground it sits on, means we can rule out whole categories of fault before we unpack the van — which is time you are not paying for.

The faults we are called to most often here

  • Communal tank and cast iron stack failures in mansion blocks
  • Escape of water affecting multiple flats at once
  • Listed stucco facade and parapet gutter penetration
  • Basement and vault ingress in Georgian terraces
  • Hotel and commercial plant room leaks

Neighbourhoods we cover in Westminster

  • Mayfair
  • Marylebone
  • Pimlico
  • Paddington
  • Soho
  • St John's Wood
  • Bayswater
  • Victoria

Plus every street in W1, W2, W9, SW1, NW1, NW8, WC2. If you are just outside, call and ask.

Services

What we do in Westminster

Every service below is available across W1, W2, W9, SW1, NW1, NW8, WC2, at the same published rates we charge everywhere else.

Equipment

How we survey a property in Westminster

Every van carries the full range. Which instrument leads depends on the pipe, the pressure and the ground it is buried in.

  • Thermal imaging camera survey

    A radiometric camera reads surface temperature through plaster, screed and tile to reveal the cold plume of an escaping supply pipe or the warm track of a heating leak.

  • Acoustic leak correlation

    Ground microphones and digital correlators listen for the specific hiss of pressurised water forcing its way out of a pipe, then triangulate the exact point.

  • Tracer gas testing

    A harmless hydrogen and nitrogen mix is introduced into drained pipework, escapes at the fault, and is picked up at the surface by a gas sensor.

  • Moisture mapping and salts analysis

    Pin and pinless meters chart how wet a structure is, and a salts test tells us whether the water arrived from a pipe, from the ground, or from the weather.

  • Pressure and flow testing

    Isolating and pressurising each circuit in turn proves which one is losing water, and how fast, before anything is opened up.

  • CCTV drainage survey

    A self-levelling camera crawls the drain run and records exactly what is broken, where it is, and how deep.

  • High-pressure water jetting

    Water at up to 3,000 psi, fired backwards through a nozzle that drags itself up the pipe, stripping the bore back to the original clay or plastic.

  • Mechanical rodding and drain snake

    Rods and a 20-metre powered snake, for blockages close to the surface and for runs too fragile or too tight to jet.

  • Chain knocker descaling and coring

    A rotating chain head or coring machine takes off what water alone will not shift — hardened scale, set concrete and cast iron corrosion.

  • Borescope inspection

    A camera on a flexible probe goes through a hole the size of a pencil to look inside a void, wall or ceiling.

  • Tracer dye testing

    Non-staining fluorescent dye is added to one water source at a time so the escaping water carries a colour-coded label.

  • Pipe and cable tracing

    A signal generator puts a tone on the pipe and a receiver follows it, so we map the route and depth before anyone digs.

  • Roof integrity and voltage testing

    Low-voltage electronic testing finds breaches in a flat-roof membrane that are invisible from the surface.

Questions

Leak detection in Westminster: your questions

How quickly can you get to Westminster?

Covered daily by our Central London engineers. We answer the phone 24 hours a day, 7 days a week and target a 1 hour response across our coverage area,

Which parts of Westminster do you cover?

All of it. We work across W1, W2, W9, SW1, NW1, NW8, WC2, including Mayfair, Marylebone, Pimlico, Paddington, Soho, St John's Wood, Bayswater and Victoria. If your postcode sits just outside that list, call and ask — we regularly work on the boundary.

What causes most leaks in Westminster?

Westminster combines listed Georgian and Regency stucco terraces in Pimlico, Belgravia and Marylebone with mansion blocks, hotels and offices, and the mansion blocks are a category of their own. Built around 1900 with communal cold water tanks in the roof and cast iron soil stacks in shared voids, a single failure in one of those systems can affect a dozen flats at once, and access to prove the source usually needs a managing agent's cooperation. In practice that means the faults we are called to most often here are communal tank and cast iron stack failures in mansion blocks, escape of water affecting multiple flats at once, listed stucco facade and parapet gutter penetration.

Who is responsible for a leak on my supply pipe in Westminster?

Mains water in Westminster is supplied by Thames Water. As a general rule the supply pipe from the boundary stop tap into your property is yours to maintain, and everything on the street side belongs to the water company. Our report states which side of that boundary the fault sits on, which matters because many water companies will repair a first leak on a customer supply pipe at no charge.

How much does leak detection cost in Westminster?

We are competitively priced and quote every job individually, the same as everywhere else we work. Call or send us the details and we will give you a price for the job before anything is booked.

Will my insurer accept a leak detection report from you?

Our reports are written to the evidence standard loss adjusters work to: calibrated moisture readings, dated photographs, a stated methodology and a clear causation finding. Trace and access cover in your buildings policy will usually pay for the survey itself as well as the damage caused by getting to the leak.

Leak in Westminster? We can be with you today.

Call 020 3411 2030 for free advice over the phone, or ask for a quote online.